Lambretta Race-Tour Inlet manifold, 28-30mm, large block with flange rubber, Race-Tour, MB
MRB0919K
MB flange type large block Race-Tour inlet manifold with flange rubber.
Suits Dellorto PHBH carbs 26, 28 and 30mm. Also fits PWK type carbs.
Perfect for MBgm Race-Tour 195/200 - 225/230 cylinder kits.
Fits all large block 200cc inlet stud spacings.
Advantages
- Fits with all types of cowlings (some may need tweaking)
- Fits with petrol tap rod
- Flange rubber locates inside the inlet manifold
- Fits with the air filter box (will need drilling to let air in)
Designed by Mark Broadhurst to give the best clearance from engine to side panels.
Kit comes complete with
- Die cast polished inlet manifold, MB
- Flange rubber, 26 - 30mm MB
- Stainless steel fasteners, MB
- Stainless steel jubilee clip
TIP: For safety use gasket sealer on all joints, retighten the fasteners after some miles.
TIP: Always fit a carb dry, if youre jetting in the bike and constantly removing the carb - wipe clean and dry the rubber and the carb. Always use wide jubilee clips! Tighten just so the carb doesnt move side to side by hand to prevent rubbers slitting. Always carry a spare and if you can bond some rubber onto the cowling to support the carb.